This close-coupled in-line pump has 2" suction and discharge ports for horizontal or vertical installation. The unit uses a stainless steel casing, impeller, and shaft, paired with a cast iron bracket and a stainless steel face plate. A mechanical seal—with a silicon carbide stationary seat, carbon rotating element, and Viton elastomers—handles temperatures up to 250°F. The 6.15" nominal diameter impeller sits within the casing, which is rated for a maximum operating pressure of 175 PSI. The in-line configuration aligns the ports to reduce piping strain, while the self-supporting design mounts directly into the system piping.
The motor is 5 HP at 3450 RPM, TEFC, operating on 230/460V, 3PH power. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.