This close-coupled in-line pump has aligned 2-inch suction and discharge ports. The casing and bracket use cast iron, while the 6.15-inch nominal diameter impeller and shaft consist of stainless steel. The hydraulic assembly includes a ceramic seat, carbon rotor, and EPT rubber seal arrangement to manage fluid temperatures up to 250°F. This self-supporting unit permits installation in either horizontal or vertical orientations without external strapping, which reduces stress on the system piping. The design includes pressure tappings for differential pressure readings and follows hydraulic standards for consistent fluid flow control in commercial hydronic applications.
The unit has a 1/2 HP, 1750 RPM, TEFC motor for 115/208-230/60/1PH power supply. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.