This in-line pump has a 2-inch suction and 2-inch discharge with a 6.15-inch nominal impeller diameter. The unit includes stainless steel construction for the casing, impeller, and shaft, paired with a bronze wear ring. It uses a replaceable bearing cartridge assembly that isolates the bearings from system fluid temperatures, combined with a Type 21 mechanical seal consisting of a ceramic seat, carbon mating ring, and EPT elastomers. This configuration handles fluid temperatures reaching 250°F. The cartridge design allows common service components across the line, while the standardized seal arrangement simplifies routine maintenance requirements.
This pump, rated for 3/4 and 1 HP applications, includes a 56 frame interface for motor mounting. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.