This in-line pump has a 2" suction and 2" discharge connection with a 6.90" nominal impeller diameter. The casing, impeller, and shaft use stainless steel construction, while the bracket includes a stainless steel face plate paired with a cast iron housing. The unit includes a replaceable bearing cartridge assembly that isolates the ball bearings from system fluid temperatures reaching 250°F. This assembly includes a standard Type 21 mechanical seal with a ceramic seat, carbon mating ring, and EPT elastomers. The standardized cartridge arrangement simplifies maintenance by allowing common service components throughout the assembly.
The motor has a 2 HP rating, 1750 RPM, ODP enclosure, and a 115/208-230/60/1 power supply. Maintenance-free operation is supported by permanently sealed, grease-lubricated motor ball bearings. Utilizing a rear pull-out design, the assembly permits complete removal of the motor and rotating components for servicing without disturbing the connected piping layout.